JM Vistec DLC-C2P6-D-E Error Err 37: Voltage required for lighting has increased too much

LED Current Controller · taken from the manufacturer’s manual, pages cited

Error codeErr 37

Voltage required for lighting has increased too much. The manual's first action is: “Check for aging of lighting or a failed LED”

Model
JM Vistec DLC-C2P6-D-E
Display shows
Voltage required for lighting has increased too much (Err 37)
Type
Error code
Source
Manual p. 18

What Err 37 means

Voltage required for lighting has increased too much p. 18

Common causes

  • Voltage required for lighting has increased too much. p. 18

What to do

  1. Check for aging of lighting or a failed LED p. 18

Before you service the product, read the safety instructions in the manual p. 3.

If Err 37 is still not resolved

  • contact your distributor Or JM Vistec p. 3
    “contact your distributor Or JM Vistec”
  • contact service / dealer p. 3
    “If in d oubt, contact your distributor Or JM Vistec”

This page summarises what the manufacturer’s manual says about Err 37; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with JM Vistec. Found a mistake? Report an error.