Heatmiser neoStat Series Error E1: The remote FLOOR probe has not been connected. The remote FLOOR probe has not been wired correctly. The remote FLOOR probe is faulty.

Heatmiser neoStat Series · taken from the manufacturer’s manual, pages cited

Fault codeE1

The remote FLOOR probe has not been connected or wired incorrectly, or is faulty. The manual lists no action for this code.

Model
Heatmiser neoStat Series
Display shows
E1
Type
Fault code
Source
Manual p. 28

What E1 means

The remote FLOOR probe has not been connected. The remote FLOOR probe has not been wired correctly. The remote FLOOR probe is faulty. p. 28

Common causes

  • The remote FLOOR probe has not been connected. p. 28
  • The remote FLOOR probe has not been wired correctly. p. 28
  • The remote FLOOR probe is faulty. p. 28

If E1 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Heatmiser service.

Open the manual at page 28 All neoStat Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about E1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Heatmiser. Found a mistake? Report an error.