Heatmiser neoStat Series Error Codes

3 codes from page 28 of the manual

This is the list of fault codes the Heatmiser manual gives for the neoStat Series Heatmiser neoStat Series. Find your code below and open it for what the manual says about its causes and what to do.

Fault codes from p. 28

CodeWhat it meansPage
E0 The internal sensor has developed a fault. p. 28
E1 The remote FLOOR probe has not been connected. The remote FLOOR probe has not been wired correctly. The remote FLOOR probe is faulty. p. 28
E2 The remote AIR probe has not been connected. The remote AIR probe has not been wired correctly. The remote AIR probe is faulty. p. 28

Codes and descriptions are taken from the manufacturer’s manual; page numbers link to the PDF. ManualLib is not affiliated with Heatmiser. Found a mistake? Report an error.