GSK GSK980TB3 Error 250: Tailstock advance/retract can not be performed in Auto mode or after the spindle is started.

GSK GSK980TB3 · taken from the manufacturer’s manual, pages cited

Alarm code250

Tailstock advance/retract can not be performed in Auto mode or after the spindle is started. The manual's first action is: “Execute M05 and then perform M10/M11.”

Model
GSK GSK980TB3
Display shows
250
Type
Alarm code
Source
Manual p. 271

What 250 means

Tailstock advance/retract can not be performed in Auto mode or after the spindle is started. p. 271

Common causes

What to do

  1. Execute M05 and then perform M10/M11. p. 271

If 250 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.

Open the manual at page 271 All GSK980TB3 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 250; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.