GSK GSK980TB3 Error 211: X-axis drive unit is not ready.

GSK GSK980TB3 · taken from the manufacturer’s manual, pages cited

Alarm code211

The X-axis drive unit is not ready due to an incorrect alarm signal level. The manual's first action is: “Adjust CNC parameter NO.8 again. Check whether the drive unit is damaged.”

Model
GSK GSK980TB3
Display shows
X-axis drive unit is not ready. (211)
Type
Alarm code
Source
Manual p. 271

What 211 means

X-axis drive unit is not ready. p. 271

Common causes

  • Level of the alarm signal is not correct. p. 271

What to do

  1. Adjust CNC parameter NO.8 again. Check whether the drive unit is damaged. p. 271

If 211 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.

Open the manual at page 271 All GSK980TB3 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 211; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.