GSK GSK980TB3 Error 207: X-axis hardware overtravel (negative).

GSK GSK980TB3 · taken from the manufacturer’s manual, pages cited

Alarm code207

The X-axis hardware has traveled beyond its negative limit. The manual lists no action for this code.

Model
GSK GSK980TB3
Display shows
X-axis hardware overtravel (negative). (207)
Type
Alarm code
Source
Manual p. 271

What 207 means

X-axis hardware overtravel (negative). p. 271

Common causes

  • When hardware detection is active, check whether the external alarm circuit is correct, or change alarm level parameter NO.8 Bit4, Bit5 or parameter NO.8 Bit2, Bit3 to 0: Shield hardware detection. p. 271

If 207 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.

Open the manual at page 271 All GSK980TB3 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 207; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.