Garmin G1000 Nav III Error S1: The G1000 has detected a failure in G/S1 receiver

G1000 Nav III · taken from the manufacturer’s manual, pages cited

Error codeS1

The G1000 has detected a failure in G/S1 receiver indicates a malfunction with the first Global Navigation Receiver, which requires replacing GIA1. The manual's first action is: “Replace GIA1”

Model
Garmin G1000 Nav III
Display shows
The G1000 has detected a failure in G/S1 receiver (S1)
Type
Error code
Source
Manual p. 80

What S1 means

The G1000 has detected a failure in G/S1 receiver p. 80

Common causes

  • The G1000 has detected a failure in G/S1 receiver. p. 80

What to do

  1. Replace GIA1 p. 80
  2. Switch GIA1 and GIA2, to verify location of problem: o If problem follows the unit, replace GIA. o If problem does not follow unit, check G/S1 antenna and cabling. p. 80

Before you service the product, read the safety instructions in the manual p. 4.

If S1 is still not resolved

  • Contact service / dealer p. 3
    “KEEP AWAY FROM LIVE CIRCUITS. Maintenance personnel shall ob serve all safety regulations at all times.”
  • Contact service / dealer p. 127
    “Loading the wrong software into GIA63/63W units may cause an inoperable condition that is not covered by warranty .”
Open the manual at page 80 All G1000 Nav III error codes Manual details & download

This page summarises what the manufacturer’s manual says about S1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Garmin. Found a mistake? Report an error.