Garmin G1000 Nav III Error ROLL: Roll Axis Failure

G1000 Nav III · taken from the manufacturer’s manual, pages cited

Error codeROLL

Roll Axis Failure means the roll axis is not working correctly, often caused by insufficient power being supplied to the affected servo. The manual's first action is: “Check that the affected servo is receiving power.”

Model
Garmin G1000 Nav III
Display shows
Roll Axis Failure (ROLL)
Type
Error code
Source
Manual p. 36

What ROLL means

Roll Axis Failure p. 36

What to do

  1. Check that the affected servo is receiving power. p. 36
  2. Check the servo wiring and connector. p. 36
  3. Ensure PTRM switches are not stuck. p. 36
  4. If failure condition still exists, remove and replace the affected servo. p. 36

Before you service the product, read the safety instructions in the manual p. 4.

If ROLL is still not resolved

  • Contact service / dealer p. 3
    “KEEP AWAY FROM LIVE CIRCUITS. Maintenance personnel shall ob serve all safety regulations at all times.”
  • Contact service / dealer p. 127
    “Loading the wrong software into GIA63/63W units may cause an inoperable condition that is not covered by warranty .”
Open the manual at page 36 All G1000 Nav III error codes Manual details & download

This page summarises what the manufacturer’s manual says about ROLL; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Garmin. Found a mistake? Report an error.