SP1 is set outside the SPL or SPH values during power up. The manual's first action is: “Set point outputs inactive Alarm active Correct the SP1, etc. or adjust the SPL or SPH values by programming new values.”
- Model
- Dwyer Instruments 1600 Series
- Display shows
- SP1
- Type
- Alarm code
- Source
- Manual p. 29
What SP1 means
This message will appear upon power up if SP1, SP2, 1rt, or 1St is set outside of the SPL or SPH values. p. 29
Common causes
- This message will appear upon power up if SP1, SP2, 1rt, or 1St is set outside of the SPL or SPH values. p. 29
What to do
- Set point outputs inactive Alarm active Correct the SP1, etc. or adjust the SPL or SPH values by programming new values. p. 29
Before you service the product, read the safety instructions in the manual p. 6.
If SP1 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Dwyer Instruments service.
This page summarises what the manufacturer’s manual says about SP1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Dwyer Instruments. Found a mistake? Report an error.