The program failed to load the DLL that contains template information, possibly due to a corrupted or incompatible file. The manual's first action is: “When the Edit Dimensions dialog was called, the program could not load the template dll. This situation may arise when attempting to edit a .GEO file of a particular geometry template that is not available in the current GC configuration.”
- Model
- Canberra 9233653E V3.0
- Display shows
- Cannot load DLL with template information (718)
- Type
- Error code
- Source
- Manual p. 440
What 718 means
Cannot load DLL with template information p. 440
Common causes
- Cannot load DLL with template information. p. 440
What to do
- When the Edit Dimensions dialog was called, the program could not load the template dll. This situation may arise when attempting to edit a .GEO file of a particular geometry template that is not available in the current GC configuration. p. 440
Before you service the product, read the safety instructions in the manual p. 526.
If 718 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about 718; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.