Canberra 9233653E V3.0 Error 716: Not a valid contour ID

Genie™ 2000 Spectroscopy Software · taken from the manufacturer’s manual, pages cited

Error code716

An invalid contour ID was provided; only 'i', 'o', or 'b' are valid. The manual's first action is: “The ID did not correspond to one of the three types of contour (i, o or b).”

Model
Canberra 9233653E V3.0
Display shows
Not a valid contour ID (716)
Type
Error code
Source
Manual p. 440

What 716 means

Not a valid contour ID p. 440

Common causes

  • Not a valid contour ID. p. 440

What to do

  1. The ID did not correspond to one of the three types of contour (i, o or b). p. 440

Before you service the product, read the safety instructions in the manual p. 526.

If 716 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.

Open the manual at page 440 All 9233653E V3.0 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 716; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.