Canberra 9233653E V3.0 Error #327: THE :ECC_OUTPUT KEYWORD IS MISSING IN 'SPACE.INI' FILE.

Genie™ 2000 Spectroscopy Software · taken from the manufacturer’s manual, pages cited

Error code#327

The :ECC_OUTPUT keyword in the 'SPACE.INI' file is missing, which stops the software from saving efficiency calibration results to disk. The manual's first action is: “Include both the :ECC_OUTPUT keyword and its definition in the ‘space.ini’ file, then try again.”

Model
Canberra 9233653E V3.0
Display shows
THE :ECC_OUTPUT KEYWORD IS MISSING IN 'SPACE.INI' FILE. (#327)
Type
Error code
Source
Manual p. 416

What #327 means

THE :ECC_OUTPUT KEYWORD IS MISSING IN 'SPACE.INI' FILE. p. 416

Common causes

  • The :ECC_OUTPUT keyword determines the folder that is used to store the results on the Efficiency Calibration Calculation [ECC]. p. 416

What to do

  1. Include both the :ECC_OUTPUT keyword and its definition in the ‘space.ini’ file, then try again. p. 416

Before you service the product, read the safety instructions in the manual p. 526.

If #327 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.

Open the manual at page 416 All 9233653E V3.0 error codes Manual details & download

This page summarises what the manufacturer’s manual says about #327; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.