Error code49
PCI configuration failed due to a faulty PC-Module or defective Tx- or RxController in the system. The manual's first action is: “1.Check insertion of the PC-Module 2.Remove the controllers one after the other and try again”
- Model
- Bruker IPSO 19"
- Display shows
- Unsuccessful PCI configuration (49)
- Type
- Error code
- Source
- Manual p. 30
What 49 means
Unsuccessful PCI configuration p. 30
Common causes
- Faultily inserted PC-Module (Host Controller) p. 30
- Any defective Tx- or RxController in the system p. 30
What to do
- 1.Check insertion of the PC-Module 2.Remove the controllers one after the other and try again p. 30
- 3.Check voltages of the Power Supply 4.Exchange the PC-Module p. 30
If 49 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Bruker service.
This page summarises what the manufacturer’s manual says about 49; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Bruker. Found a mistake? Report an error.