Industrial

MM54C240 and MM74C240 are eight-channel buffers and line drivers with TRI-STATE outputs, specially designed for driving capacitive loads such as bus systems.

The document describes the features and characteristics of an inductor product called MLF Series, including high-reliability monolithic structure, ferrite core, and magnetic shielding. It is suitable for personal computers, HDDs, and various other electronic appliances.

Strata Digital Business Telephone System User Guide

The features and characteristics of the MCP1701 series of low voltage drop linear regulators are introduced, including working voltage range, output current, static current, output voltage, package type, application scenarios, etc.

The MCM6323A is a 64K x 16-bit static random access memory produced by Motorola. It is powered by 3.3V and has a working frequency of 10, 12, 15ns. All inputs and outputs are TTL compatible and it supports byte control and fully static operation. The maximum working current is 140/135/130 mA.

56F8366/56F8166 is a 16-bit digital signal controller produced by freescale. It contains a 36-bit multiplier, 3 16-bit input registers, 4 36-bit accumulators, an external address bus switch, an external data bus switch, program memory, a boot ROM, and a data memory.

The MAX889 is a high-frequency, adjustable, 200mA inverting charge pump that delivers a regulated negative output voltage at loads of up to 200mA. The device operates with inputs from 2.7V to 5.5V to produce an adjustable, regulated output from -2.5V to -VIN. The MAX889 is available with an operating frequency of 2MHz (T version), 1MHz (S version), or 0.5MHz (R version). The higher switching frequency devices allow the use of smaller capacitors for space-limited applications. The lower frequency devices have lower quiescent current. The MAX889 also features a 0.1µA logic-controlled shutdown mode and is available in an 8-pin SO package. An evaluation kit, MAX889SEVKIT, is available.

The AD8131 is a high performance, low cost differential driver with 400 MHz bandwidth, 2000 V/µs slew rate and 2 fixed gain, which can be used for video line driver, digital line driver, low power differential ADC driver etc.

The AD8324 is a low cost amplifier designed for coaxial line driving. The features and specifications make the AD8324 ideally suited for DOCSIS 2.0 and Euro-DOCSIS applications. The gain of the AD8324 is digitally controlled in 1 dB steps over a 59 dB range. Low distortion at 61 dBmV output: -59 dBc SFDR@21 MHz, -54 dBc SFDR@65 MHz. Output noise level @ minimum gain 1.3 nV/√Hz. Maintains 75 Ω output impedance in TX-enable and Transmit-disable condition. Upper bandwidth: 100 MHz (full gain range). Supports SPI® interfaces.

The document describes the features and characteristics of the AD8139 differential ADC driver, including low noise, rail-to-rail operation, differential input and output, and high speed.

AD8134 is a three-way differential driver from Analog Devices, it uses Sync-On-Common-Mode technology, it has 225 MHz, -3 dB large signal bandwidth and 450 MHz, -3 dB small signal bandwidth. AD8134 can easily drive 1.4 V p-p video signal into doubly terminated 100 Ω UTP cable.

AD8133 Rev. 0 is a triple differential driver with output pull-down feature. It features high speed, low distortion, low power consumption, and is suitable for applications such as KVM networking and UTP.

The ADA4302-4 is an active RF splitter used in applications where a lossless signal split is required. It features a single 5V supply, 54MHz to 865MHz CATV operating range, 4.6dB gain per output channel, 4.4dB noise figure, 25dB isolation between output channels, etc.

The AD8337 is a low noise, single-ended, linear-in-dB, general-purpose variable gain amplifier (VGA) usable for video, imaging, medical imaging, industrial radar, and other applications. It features low noise, wide bandwidth, low power, single-ended input and output, and high speed uncommitted op amp input, making it suitable for a variety of applications.

AD8143 is a high-speed, triple differential receiver with comparators. It features a large signal bandwidth of 160 MHz, slew rate of 1000 V/μs, high CMRR of 65 dB, and a differential input impedance of 5 MΩ.