Industrial

The document describes the features and characteristics of a product called the "[product_name]".

SFR101 – SFR107 is a soft fast recovery rectifier produced by Won-Top Electronics. It features low forward voltage drop, high current, high reliability, and high surge current capability.

This data sheet provides the characteristics parameters of SD520S-SD5100S surface mount Schottky barrier rectifiers.

SD253N/R Series 1 is a fast recovery diode produced by IRF company with high power and high voltage features.

The SC8863 is a low dropout linear regulator from Semtech that can operate from a +2.5V to +6.0V input voltage range and delivers up to 150mA of current. The SC8863 uses a PMOS pass transistor, which allows the low 110µA supply current to remain independent of load, making it ideal for battery operated portable equipment such as cellular phones, cordless phones and personal digital assistants. The SC8863 output voltage can be preset or adjusted with an external resistor divider. Other features include low power shutdown, short circuit protection, thermal shutdown protection and reverse battery protection. The SC8863 comes in the tiny 5 lead SOT-23 package (lead free, fully WEEE and RoHS compliant available) and the ultra low profile 5 lead TSOT-23.

SB520S - SB5B0S SCHOTTKY BARRIER RECTIFIER DIODES is a Schottky diode product produced by ON Semiconductor.

The SAA7113H 9-bit video input processor features four analog inputs, internal analog source selectors, automatic switching, automatic frequency tracking, automatic white balance, and automatic gamma correction.

SA702 is a triple modulus low power ECL prescaler from Philips, used in synthesizer systems to achieve low phase lock time, broad operating range, high reference frequency and small frequency step sizes.

SA56614-XX is a CMOS device designed to generate a reset signal for a variety of microprocessor and logic systems. Accurate reset signals are generated during momentary power interruptions, or whenever power supply voltages sag to intolerable levels.

SA25C020 is a 2Mb (512K x 4) CMOS non-volatile serial EEPROM, fully complies with the SPI 4-wire protocol, is enabled through the Chip Select (CSb) pin, and uses Clock (SCK), Data-in (SI) and Data-out (SO) pins to synchronously control data transfer between the SPI microcontroller and EEPROM.

NMOS linear image sensors are self-scanning photodiode arrays designed specifically as detectors for multichannel spectroscopy. The scanning circuit is made up of N-channel MOS transistors, operates at low power consumption and is easy to handle. Each photodiode has a large active area, high UV sensitivity yet very low noise, delivering a high S/N even at low light levels. NMOS linear image sensors also offer excellent output linearity and wide dynamic range. The photodiodes of S3901 series have a height of 2.5 mm and are arrayed in a row at a spacing of 50 µm. The photodiodes of S3904 series also have a height of 2.5 mm but are arrayed at a spacing of 25 µm. The photodiodes are available in 3 different pixel quantities for each series: 128 (S3901-128Q), 256 (S3901-256Q, S3904-256Q), 512 (S3901-512Q, S3904-512Q) and 1024 (S3904-1024Q). Quartz glass is the standard window material.

RPM3 UHF FM Radio Packet Modem is a low cost intelligent radio packet modem that enables a two way radio network/link to be simply implemented between a number of digital devices.

This document describes the features and characteristics of the RP20-S_DEW series 20 Watt single and dual output POWERLINE DC/DC converters, including wide input voltage range, fixed operating frequency, 1.6kVDC isolation, etc.