Industrial

This product is VNN3NV04P-E, VNS3NV04P-E OMNIFET II fully autoprotected Power MOSFET, which has linear current limitation, thermal shutdown, short circuit protection, integrated clamp, low input current, diagnostic feedback, ESD protection, direct access to MOSFET gate etc.

This document describes a voltage regulator that uses Super Linear Regulator technology to regulate the voltage of a Li-po battery to 6.5V without noise and radio glitch. The specifications of the product include the required battery type, standby current, maximum constant current, connector type, and applicable categories.

This datasheet describes the features of the OMNIFET II fully autoprotected Power MOSFET VNN7NV04P-E and VNS7NV04P-E, including linear current limitation, thermal shutdown, short circuit protection, integrated clamp, low input pin current, diagnostic feedback, ESD protection, direct access to the gate of the Power MOSFET (analog driving) and compatibility with standard Power MOSFET in compliance with the 2002/95/EC European Directive.

VN5E010MH-E is a single-channel high-side driver manufactured in ST proprietary VIPower M0-5 technology and housed in the tiny HPAK package. The VN5E010MH-E is designed to drive 12 V automotive grounded loads delivering protection, diagnostics and easy 3 V and 5 V CMOS compatible interface with any microcontroller. The device integrates advanced protective functions such as short circuit protection, overvoltage protection, undervoltage shutdown, overcurrent protection and thermal shutdown.

The VNH5019A-E is a full bridge motor driver from STMicroelectronics. The product has a 30A output current, uses ECOPACK® packaging, supports 3V CMOS compatible inputs, and integrates thermal shutdown functions on both the high and low sides. In addition, the product also has overvoltage protection, undervoltage protection, cross conduction protection, current limiting, extremely low standby power consumption, PWM operation, overcurrent protection, reverse polarity protection, etc.

This is a PDF document about VND5004B-E VND5004BSP30-E, it is a double 4mΩ high side driver with analog current sense for automotive applications. It has the following features: active power management, very low standby current, 3.0 V CMOS compatible input, optimized electromagnetic emission, very low electromagnetic susceptibility, in compliance with the 2002/95/EC European directive. Diagnostic functions include proportional load current sensing, current sense disable, thermal shutdown indication. Protection functions include undervoltage shutdown, overvoltage clamp, load current limiting, thermal shutdown, self limiting of fast thermal transients, protection against ground loss and loss of VCC, reverse battery protection with self switch on of the Power MOSFET (see Figure 22), electrostatic discharge protection application. Suitable for all types of resistive, inductive and capacitive loads, suitable for power management applications.

This document describes the features and characteristics of Analog Devices' OP249 dual, precision JFET high-speed operational amplifier, including fast slew rate, high open-loop gain, and low offset voltage.

This item is connectable Muchmore Super Linear Regulator(SLR) and monitors output voltage's status by its LED color. Blue LED tells you SLR has enough voltage to operate, on the other hand Red LED is means it's time to recharge your battery(or SLR is overloaded)

The CTX regulator is used to regulate the voltage (7.4V) of a Li-Po battery to 6.5V.

MIA-CP Special Carpet Mold Tire Inserts for carpet track.

The document introduces the features of the product. The product is produced by Muchmore.

The OP245PS is an 850 nm, infrared emitting diode molded in IR transmissive amber-tinted epoxy packages. It features a point source irradiance pattern, wavelength matched to silicon’s peak response, fast switching speed, and a side-looking package for space limited applications. It is ideal for use in PC board mounted slotted switches or as easily mounted interrupt detectors. Its stable VF vs. Temperature characteristic makes it suitable for applications where voltage is limited, and its low tr/tf makes it ideal for high-speed operations.