Industrial Manuals

This is a S parameter simulation technical information manual for XC2401A8167R-G

This document introduces the features and characteristics of the XC6401 series products. The XC6401 series products are a 2chVR that can be voltage converted by external control and only use a single load capacitance (CL). In addition, compared to when any one of EN1 or EN2 is in working mode, the operating current (ISS) is approximately 2 times (about 50uA).

Introduced the selection and application of multi-function VDR, including input voltage range, operating current, output voltage range, output voltage accuracy, transient response, ripple rejection, maximum output current, limiting current, short circuit current, on-resistance, detect voltage range, detect voltage accuracy, delay voltage, output type, delay function type, EN function type, CE function type, CE/EN, CE/EN pull-up resistor, package type, PIN definition, and wafer substrate type.

This document is a guide for the installation of the Summit-ICE emulator hardware and software. It describes the features and characteristics of the product.

This document introduces the features and applications of industrial standard SUB-D-connectors

The UE 6 is a measurement module in the A T R Europa Card series. It contains 20 measurement jacks and 5 solder support points. The module can be connected to 2mm plugs and directly connected to the measurement bar. 2 additional jacks are connected to ground.

NG 3005 - NG 3024 is a linearly controlled power unit produced by A T R Industrie - Elektronik GmbH. It has three output voltages: 5V, 15V and 24V, and the output current is 3A.

NE 1505 - NE 1524 is a 19-inch card-type double power supply module from ATR Industrie - Elektronik GmbH, which supports 5Vdc, 15Vdc or 24Vdc output, with an output current of 1.25.1.5A.

This document introduces a sensor unit for detecting a workpiece (electrically conductive).

The GG8005 is a regulated DC/DC converter that can be snap-on mounted onto support rails. It is suitable for applications where a fixed voltage is required but no suitable power supply is available, such as switch cabinets and control panels. The converter operates with an input voltage of 20.32Vdc.

The document introduces the DC / DC converters GG 115 and GG 1005 produced by ATR Industrie-Elektronik GmbH, including input and output voltage, current, conversion efficiency, etc.

This document describes the technical features of LabVIEWTM LabWindows/CVITM, including the parameters and functions of its analog inputs and outputs.