STMicroelectronics Manuals

This document is the specification of the STP9NM60N series products, which describes the features and characteristics of the products in detail, including pin definition, package type, electrical parameters, absolute maximum ratings, thermal data, avalanche characteristics and so on.

an1501 is an application note that introduces how microcontroller can be used in electronic ballast, and provides a brief introduction of the basic working principle of microcontroller and the advantages and disadvantages of implementing microcontroller in electronic ballast.

This application note describes a low cost power board design for the ST92141 motor control MCU without using IPMs.

This Application Note describes how to emulate this feature with a ST72F264 device and the restrictions this emulation implies.

This application note describes how to develop a USB Mass Storage application using an ST7265x microcontroller. The proposed solution includes a generic USB Mass Storage Layer (MSL) compliant with the USB Mass Storage Class that can be used for all types of storage media (FLASH memory cards, hard disk drive, etc.) and a dedicated Media Access Layer (MAL) add-in for each type of storage media. The MSL and the MAL modules are available to ST customers on request. Contact your ST sales office to obtain the ST7265 Mass Storage software. The MSL and the MAL must be considered as function libraries and therefore cannot be modified by the user. The software interfaces of these function libraries provide the user with the required flexibility for designing his application: – type and number of media, – insertion/withdrawal management, – protection management, – user interface. Note that the MAL requires the use of certain fixed MCU pins to interface with the various mediums. As a result, a specific application hardware configuration is required when using the MAL.

Describes how to use ST7 microcontroller's 8-bit SPI to emulate a 16-bit SPI slave

How to reduce 3rd harmonics with ST6200C motor control software

This AN1449 application note describes the software of a low-cost phase-angle motor control drive system based on an OTP version of the ST6200C microcontroller and a BTB16-600CW snubberless triac.

This application note describes several low-cost power supply circuits for home appliance applications. These circuits can be built with simple components and are very cost-effective.

This application note provides guidelines on resolving several common application problems that have been reported by ST Application Engineers.

This document describes how the ST72521 emulator supports software development for the ST72324 target MCU, as well as the differences between the two and their impact on software development.

This is an application note that introduces LIN bus, features of LIN bus and ST's LIN silicon products.

Introduces the ST7 MCU series with pCAN peripheral devices and provides drivers and usage methods