STMicroelectronics Manuals

The VN772K is a quad smart power solid state relay for complete H-bridge configurations. It has features such as low voltage bridge, linear current limitation, very low standby power dissipation, short circuit protection, status flag diagnostic (open drain), integrated clamping circuits, undervoltage protection and ESD protection.

The VN771K is a low voltage bridge-type quad smart power solid state relay from STMicroelectronics, which features linear current limiting, very low standby power dissipation, short circuit protection, status flag diagnostics (open drain), integrated clamping circuits, undervoltage protection and ESD protection.

The L5959 is a multifunction voltage regulator from ST company. It can be used in car radios. The chip has four outputs: 8.5V@200mA, 8/10V@1000mA (selectable 10V or 8V), 3.3V@100mA (permanent) and 3.3V@800mA (switched power supply). In addition, L5959 has two protected HSD, reset function, battery voltage (under/over) warning output, load dump protection, independent thermal shutdown, overcurrent limitation, storage capacitor output (STCAP), small capacitor required by stability of regulators and all pins ESD protection.

L9805E is a super smart power motor driver from ST, which includes 8-bit MCU, RAM, EEPROM, ADC, WDG, timers, PWM and H-bridge driver, etc. It has a supply operating range of 6.4-18V, a maximum oscillator frequency of 16MHz, a maximum internal clock frequency of 8MHz, an oscillator supervisor, a fully static operation, a temperature range of -40°C to +150°C, a user EPROM/OTP of 16K bytes, a data RAM of 256 bytes, a data EEPROM of 128 bytes, a 64-pin HiQUAD64 package, 10 multifunctional bidirectional I/O lines, two 16-bit timers (each timer includes 2 input captures, 2 output compares, external clock input (on timer 1) and PWM and pulse generator modes), two programmable 16-bit PWM generator modules, a CAN peripheral including bus line interface according to 2A/B passive specifications, a 10-bit analog-to-digital converter, a software watchdog for system integrity, a master reset, a power-on reset, a low voltage reset, a 90mΩ DMOS H-bridge, etc.

TDA7540B is an AM/FM car radio tuner IC with stereo decoder and Intelligent Selectivity System (ISS) manufactured by Texas Instruments.

This document describes a 16-bit MCU called ST10F276E, which features a MAC unit, 832 KB Flash memory, and 68 KB RAM. It has a highly performance 16-bit CPU with DSP functions, a fast instruction cycle time, and a multiply/accumulate unit. It also supports enhanced boolean bit manipulations and single-cycle context switching. The MCU includes various on-chip and external memories, an external bus, an interrupt controller, timers, an A/D converter, and serial channels.

This document describes the VND5012AK-E double channel high side driver with analog current sense for automotive applications. Its features include inrush current active management by power limitation, very low standby current, 3.0V CMOS compatible input, optimized electromagnetic emission, and very low electromagnetic susceptibility.

VND5050AJ-E and VND5050AK-E are double channel high side drivers with analog current sense for automotive applications. They feature main inrush current active management, very low standby current, 3.0 V CMOS compatible input, optimized electromagnetic emission, and very low electromagnetic susceptibility.

VND5050J-E VND5050K-E double channel high side driver for automotive applications. The features of the driver include: main inrush current active management by power limitation, very low standby current, 3.0 V CMOS compatible input, optimized electromagnetic emission, very low electromagnetic susceptibility, compliance with the 2002/95/EC European directive, diagnostic functions, open drain status output, on-state open load detection, off-state open load detection, thermal shutdown indication, undervoltage shutdown, overvoltage clamp, output stuck to VCC detection, load current limitation, self limiting of fast thermal transients, protection against loss of ground and loss of VCC, thermal shutdown, reverse battery protection (see Figure 28) and electrostatic discharge protection. Applications include all types of resistive, inductive and capacitive loads

The ST10F273E 16-bit MCU is a high-performance MCU introduced by ST company. It has a 31.25ns instruction cycle time and a maximum CPU clock of 64 MHz. It has 512Kbyte of Flash memory and 36Kbyte of RAM.

The TDA7333N circuit is a RDS/RDBS signal processor, intended for recovering the inaudible RDS/RBDS informations which are transmitted on most FM radio broadcasting stations.

This document provides information on a 16-bit MCU with 256 Kbyte Flash memory and 12/20 Kbyte RAM. The product features a 16-bit CPU with DSP functions, offering a fast instruction cycle time and a multiply/accumulate unit. It also includes various on-chip memories, programmable external bus configuration, interrupt system, timers, A/D converter, and serial channels. The MCU is suitable for applications requiring high performance and versatile functionality.

The L9942 is an integrated stepper motor driver for bipolar stepper motors with microstepping and programmable current profile look-up-table to allow a flexible adaptation of the stepper motor characteristics and intended operating conditions.

VNS3NV04D-E is an OMNIFET II fully autoprotected Power MOSFET with features like linear current limitation, thermal shut down, short circuit protection, integrated clamp, etc. It is designed for DC up to 50KHz applications and offers fault feedback and ESD protection.

The L9466 is a monolithic multifunction generator Voltage regulator intended for use in automotive charging applications. This All Silicon Voltage Regulator regulates the output of an automotive generator by controlling the field winding current by means of a variable frequency PWM high side driver.