ANALOG Manuals

This document describes the features and characteristics of the AD5933, a 1 MSPS, 12-bit impedance converter and network analyzer.

AD5930 is a programmable frequency sweep and output burst waveform generator with programmable frequency profile.

The datasheet introduces AD5932, a programmable frequency scan waveform generator. The device utilizes embedded digital processing to achieve enhanced frequency control, and can generate synthesized sinusoidal, triangular and square waves.

This document describes the features and characteristics of the 500 MSPS Direct Digital Synthesizer AD9911, including patented SpurKiller technology, multitone generation, test-tone modulation, etc.

AD9957 is a 1 GSPS digital upconverter with integrated 1 GSPS 14-bit DAC and 250 MSPS input data rate.

1 GSPS, 14-Bit, 3.3 V CMOS Direct Digital Synthesizer Data Sheet AD9910 Rev. D is a frequency synthesizer produced by American Analog Devices company. Its main features are the internal clock speed up to 1 GSPS, support for 14-bit DAC, frequency resolution up to 0.23 Hz, phase noise as low as -125 dBc/Hz @ 1 kHz offset (400 MHz carrier), and excellent dynamic performance with bandwidth SFDR up to >80 dB.

The AD9913 Rev. A is a low power 250 MSPS 10-bit DAC 1.8 V CMOS Direct Digital Synthesizer.

The AD9912 is a 1 GSPS direct digital synthesizer with integrated 14-bit DAC that provides high performance, low jitter, and compact passive LO frequency synthesis for a variety of applications.

The AD9838 is a low power DDS device capable of producing high performance sine and triangular outputs. It also has an on-board comparator that allows a square wave to be produced for clock generation. Consuming only 11 mW of power

The AD9837 is a low power, programmable waveform generator capable of producing sine, triangular, and square wave outputs.

The AD9352 is a fully integrated RF transceiver with integrated ADCs and DACs, designed for WiMAX/WiBro applications. It offers superior receiver sensitivity and highly linear transmitter characteristics, with features such as automatic gain control and transmit power control.

The AD9353 is a fully integrated WiMAX RF MxFE transceiver that integrates ADCs and DACs, operates in the 3.3 to 3.8 GHz band, and has a bandwidth of 3.5 to 20 MHz. The AD9353 has a low noise figure of 3.2 dB and a highly linear and spectrally pure transmitter.

The AD9355 is a dual-receiver, single-transmitter radio frequency (RF) transceiver that supports the IEEE 802.16 WiMAX/WiBro standard. It has a bandwidth of 3.5 MHz to 10 MHz, a receiver sensitivity of up to NF<3.5 dB, and a transmit power control range of 58 dB with a resolution of 0.25 dB.

The AD9354 is a radio frequency (RF) transceiver with a single integrated ADC and DAC, supporting the IEEE 802.16 WiMAX/WiBro standard. The bandwidth is 3.5 MHz < BW < 10 MHz, the receiver sensitivity is high, the noise figure is less than 3.5 dB, and it supports manual Rx gain and autonomous AGC mode. The transmitter has high linearity and spectral purity, the output power control range is 58 dB, and the resolution is 0.25 dB. It integrates a fractional-N synthesizer, the LO step size is 10 Hz, the LO integrated phase noise is less than 0.4°rms, and the automatic frequency correction accuracy is less than 0.012 ppm. It supports the industry-standard JESD-207 digital interface.

The AD9356 is a 2x2 MIMO RF transceiver that supports WiMAX/BWA/WiBRO/LTE bands, with bandwidth of 3.5-10MHz, superior receiver sensitivity with NF<3.2dB, highly linear and spectrally pure transmitter Tx EVM:-40dB, SNR:>130dB/Hz.