This page provides manuals, user guides, handbooks, instructions, specification, instruction, maintenance manual for ANALOG Video Player, Industrial Supply, ...
This document describes the features and characteristics of Analog Devices AD73311, a low-cost, low-power CMOS general-purpose analog front end. The product features a 16-bit A/D and D/A converter, programmable input/output sample rates, high SNR, low group delay, etc.
The ADuC834 is a complete smart transducer front end, integrating two high resolution ADCs, an 8-bit MCU, and program/data Flash/EE memory on a single chip.
This document describes the features and characteristics of the AD7327 model from Analog Devices. The product is an 8-channel 12-bit plus sign ADC with software-selectable true bipolar input ranges. It offers high resolution and sampling rate, and allows for selection of different input ranges. Additionally, it features low power consumption, high-speed serial interface, and multiple power-down modes.
AD8061/AD8062/AD8063 are low cost, 300MHz rail-to-rail amplifier with low distortion and low power consumption, suitable for video, image processing and other applications.
The ADSP-BF561 EZ-KIT Lite™ provides developers with a cost-effective method for initial evaluation of the ADSP-BF561 Blackfin® Processor for audio and video applications via a USB-based PC-hosted tool set.
This document describes the features and characteristics of the AD8651/AD8652 low noise CMOS amplifiers, including 50 MHz bandwidth, low noise, low distortion, 4.5 nV/√Hz noise, 100 µV offset voltage, 1 pA input bias current, etc.
AD694 is a 4-20mA current sensor from Analog Devices. This sensor is an integrated circuit design that can accept high-level signal inputs and convert them to standard 4-20mA current loop outputs to control valves, actuators and other devices commonly used in process control. The input signal is buffered by an input amplifier that can be used to scale the input signal or buffer the output from a current mode DAC. Pre-calibrated input ranges of 0 V to 2 V and 0 V to 10 V are selected by simple pin strapping; other ranges can be programmed with external resistors. The output stage compliance extends to within 2 V of VS and its special design allows the output voltage to extend below common in dual supply operation. An alarm warns of an open 4-20 mA current loop.
AD8551/AD8552/AD8554 is a zero-drift, single-supply, rail-to-rail input/output operational amplifier. Its features include low offset voltage, low input offset drift, wide input and output swing, single-supply operation, high gain, and common mode rejection ratio.
AD822 is a single-supply, rail-to-rail low power FET-input op amp with true single-supply operation, output swings, voltage range, load drive capability, low power, high AC performance, good DC performance, low noise and no phase inversion.
AD8061/AD8062/AD8063 are low-cost, 300 MHz rail-to-rail amplifiers. Features low offset voltage, high output swing, high speed, low power consumption. Mainly used in imaging, photodiode preamplifiers, professional video and cameras, hand sets, DVDs/CDs, base stations, filters, ADC drivers, etc.
