ST Manuals (Industrial)

The LD1117 series is a low drop positive voltage regulator, available in fixed and adjustable version. The device can provide up to 800mA of output current and is supplied in different packages.

File format: PDF Size:625 KB

The STPS41H100CG/CT/CR is a 3A low drop power Schottky rectifier, suitable for Switch Mode Power Supply and high frequency DC to DC converters. Packaged in D2PAK, I2PAK and TO-220AB, this device is intended for use in high frequency inverters.

File format: PDF Size:99 KB

File format: PDF Size:0 KB

VIPer53 is the third generation of the Viper series and combines an enhanced current mode PWM controller with a high voltage MDMesh Power Mosfet. It features up to 300 kHz switching frequency, adjustable current limiting, soft start and shut down control, automatic burst mode, high voltage startup current source, over temperature protection, overload and short circuit control.

File format: PDF Size:260 KB

The M29DW323DT M29DW323DB 32 Mbit (4Mb x8 or 2Mb x16, Dual Bank 8:24, Boot Block) 3V Supply Flash Memory features 70ns access time, 10µs per Byte/Word typical program time, support Fast Program (optional) VPP = 12V, support 8Mbit+24Mbit dual bank memory array, support top or bottom location parameter blocks, support read in one bank while program or erase in other, support erase suspend and resume modes, support read and program another block during erase suspend, support bypass program command unlock, support VPP/WP pin for FAST PROGRAM and WRITE PROTECT, support temporary block unprotection mode, support 64 bit security code, support extended memory block, support low power consumption, support standby and automatic standby, support 100,000 program/erase cycles per block, and support electronic signature (manufacturer code: 0020h, top device code M29DW323DT: 225Eh, bottom device code M29DW323DB: 225Fh).

File format: PDF Size:1028 KB

ST485B is a low power RS-485/RS-422 transceiver from ST. It features low quiescent current (300µA), -7V~12V input voltage range, 30ns propagation delay and 5ns skew.

File format: PDF Size:728 KB

The TL061 is a low power J-FET single operational amplifier family with high input impedance, low bias current, low output impedance and high open loop gain.

File format: PDF Size:308 KB

STW26NM60 is a 600V-0.125Ω-30A N-channel MOSFET with typical RDS(on)=0.125Ω, high dv/dt and avalanche capabilities, improved ESD capability, low input capacitance and gate charge and low gate input resistance. It is suitable for increasing the power density of high voltage converters, allowing system miniaturization and higher efficiencies.

File format: PDF Size:233 KB

This document describes the features and characteristics of products such as STP11NM80, STF11NM80, STB11NM80, and STW11NM80, including low on-resistance, low input capacitance and gate charge, and suitability for single switch applications.

File format: PDF Size:420 KB

The MC3x174 series are quad bipolar operational amplifier offering both low consumption (200µA) and good speed (2.1MHz, 2V/µs). Moreover the Input Common Mode Range ex- tends down to the lower supply rail, allowing single supply operation from +4V to +44V.

File format: PDF Size:84 KB

TDA1175P is a low-noise vertical deflection system, suitable for high-definition monitors. It integrates synchronization circuit, oscillator and ramp generator, high power gain amplifier, flyback generator, voltage regulator and other functions.

File format: PDF Size:289 KB

The L4941 is a three-terminal 5V positive regulator available in TO-220, TO-220FP and D2PAK packages, making it useful in a wide range of industrial and consumer applications.

File format: PDF Size:949 KB

spa c 265-3w is a switch mode power supply module produced by stmicroelectronics, which has wide input voltage range, low standby power consumption, high reliability and other features, and is suitable for industrial and information technology equipment

File format: PDF Size:271 KB

TDA2007A is a class AB dualAudio power amplifier chip with high output power and high current capability, specially designed for stereo application in music centers, TV receivers, and portable radios.

File format: PDF Size:120 KB

TDA2007A is a 6 + 6W stereo amplifier from Dinghao. It is assembled in a SIP9 package and has high output power, high current capability, AC short circuit protection and thermal protection. It is suitable for use in music centers, TV receivers and portable radios.

File format: PDF Size:120 KB

TDA2008 is a 12W audio power amplifier from Texas Instruments (TI). It is designed for operation at 22V with a 4-ohm load. The device features very low harmonic and crossover distortion and is housed in a Pentawatt package. It also offers other features such as very low external component count, easy assembly, space and cost savings, high reliability, flexibility in use and thermal protection.

File format: PDF Size:126 KB

The TDA2008 is a monolithic class B audio power amplifier designed for driving low impedance loads. It provides a high output current capability, very low harmonic and crossover distortion. The device offers features such as few external components, easy assembly, space and cost saving, high reliability, flexibility in use, and thermal protection.

File format: PDF Size:126 KB

TDA2009A is a class AB dual Hi-Fi Audio power amplifier assembled in Multiwatt  package, specially designed for high quality stereo application as Hi-Fi and music centers.

File format: PDF Size:198 KB

TDA2006 is a 12W audio amplifier. Its working voltage is ±12V, its output power is 12W, its output current is 3A, and it has very low harmonic and crossover distortion.

File format: PDF Size:199 KB

File format: PDF Size:199 KB