Key facts
- Brand
- Trinamic
- Model
- TMC2300
- Category
- INTEGRATED CIRCUITS
- Industry
- Electronics
- Documents
- 2
- Languages
- EN
- Last added
- 2026-11-15
Start here

TRINAMIC TMC2300-MOTOR-EVAL Hardware Manual
This document is the hardware manual for the TMC2300-MOTOR-EVAL evaluation board. The board allows users to evaluate the TMC2300-LA stepper motor driver in combination with a small built-in permanent magnet stepper motor or an external 4-pin ST-PH connector motor.
Read onlineTRINAMIC TMC2300 specifications
| Supply Voltage Range | 2V (1.8V min) to 11V DC |
|---|---|
| Motor Current | 1.2A RMS, 2A peak per coil |
| Standby Current | <50nA typical |
| Microstep Resolution | Up to 256 microsteps via microPlyer interpolation |
| RDSon (Low/High Side) | 170mΩ typical each |
| Package | QFN20 3x3mm with exposed die pad |
| Control Interface | STEP/DIR and single-wire UART |
All TRINAMIC TMC2300 documents by type
Ratings, dimensions and ordering codes, for selection and design work.
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What is the supply voltage range for the TMC2300?
The TMC2300 operates from 2V (1.8V minimum) to 11V DC, suitable for battery-powered devices.
What is the maximum motor current the TMC2300 can drive?
The driver supports up to 1.2A RMS and 2A peak current per coil.
What type of battery is required for the TMC2300-MOTOR-EVAL?
The board requires a Li-lon battery of type 18650 with integrated protection.
How is the TMC2300-MOTOR-EVAL powered?
It can be powered by an onboard Li-lon cell or an external stabilized supply with a maximum level of 5V.
