Key facts
- Brand
- Toyota
- Model
- 2010 Toyota Prius
- Category
- Vehicle maintenance
- Documents
- 6
- Languages
- EN
- Last added
- 2023-10-20
Start here

Toyota 2010 Prius Repair Manual
This repair manual provides detailed instructions for servicing the quarter window assembly on a 2010 Toyota Prius. It covers removal and installation procedures, including using butyl tape for temporary support, applying primer and adhesive, and ensuring proper clip engagement. The guide also includes inspection steps to check for leaks after installation.
The manual includes specific measurements and warnings, such as applying primer to exposed vehicle body surfaces and ensuring adhesive cures for a minimum time before driving, depending on ambient temperature.
Toyota 2010 Toyota Prius specifications
| Rear Wheel Torque | 103 N·m (1050 kgf·cm, 76ft·lbf) |
|---|---|
| Rear Suspension Brace Torque | 54 N·m (551 kgf·cm, 40ft·lbf) |
| No. 3 Parking Brake Cable Torque | 6.0 N·m (61 kgf·cm, 53in·lbf) |
All Toyota 2010 Toyota Prius documents by type
Disassembly, diagnostics and part numbers, for repair.
- Toyota 2010 Prius Repair Manual 13 p
- 2010 Toyota Prius Brake System Repair Manual 22 p
- 2010 Toyota Prius Engine Removal and Installation Service Manual 49 p
- 2010 Toyota Prius Cylinder Head Removal and Installation Service Manual 7 p
- 2010 Toyota Prius Repair Manual 33 p
- 2010 Toyota Prius Parking Brake System Repair Manual 30 p
Questions answered in these manuals
What is the minimum time required to wait before driving the vehicle after installing the quarter window at 20°C?
You must wait 5 hours before driving the vehicle if the temperature is 20°C.
What force is required to press the quarter window glass during installation?
You must press the glass with a force of 98 N or more.
What must be done if brake fluid leaks onto painted surfaces?
Immediately wash it off to prevent damage.
Is initialization required after replacing the height control sensor?
Yes, some systems need to be initialized after the rear height control sensor sub-assembly is replaced.
What is the torque specification for the engine hangers?
The torque specification for the engine hangers is 43 N·m (438 kgf·cm, 32ft·lbf).
From: 2010 Toyota Prius Engine Removal and Installation Service Manual
How should the O-ring for the engine oil level dipstick guide be prepared?
A light coat of engine oil should be applied to a new O-ring before installation.
From: 2010 Toyota Prius Engine Removal and Installation Service Manual
