Key facts
- Model
- EG3002
- Category
- Industrial Robot
- Documents
- 2
- Languages
- EN
- Last added
- 2023-10-19
Start here
Kutai EG3002 Electronic Engine Governor Controller User Manual
The EG3002 is an electronic engine governor controller designed to maintain constant engine speed by comparing a magnetic pickup signal with a preset speed. It supports external, built-in, and PT-pump actuators, with settings for Cummins PT-Pump and 'extreme slow response' engines. The unit operates on 10–32 Vdc and features adjustable speed droop, ramp time, and idle speed. It includes DIP switches for frequency range selection and potentiometers for fine-tuning parameters like gain, integral, and derivative settings. Installation requires shielded cables and proper grounding to avoid noise interference. Safety warnings advise against over-speed operation and recommend external over-speed protection.
Wiring and adjustment procedures are detailed, including terminal connections for battery, actuator, MPU, and remote speed control. Initial setup involves selecting the correct frequency range based on engine RPM and flywheel teeth, adjusting idle and run speed, and calibrating gain, integral, and derivative settings for stable operation. Parallel generator operation is supported with adjustable speed droop for load sharing. The manual includes troubleshooting tips for engine start issues and speed instability.
Kutai Electronics Industry Co., Ltd. EG3002 specifications
| Outputs | Max. 95% of Input Voltage |
|---|---|
| Current Continuous | 7A min. 0.5A Max. 15A 10 seconds |
| Static Power Consumption | Less than 1 Watt @ 12 Vdc |
| Speed Temperature Shift | Less than 3% at temperature range -40 to +80 ˚C |
| Operating Temperature | -40 to +80 ˚C |
| Storage Temperature | -40 to +85 ˚C |
| Ramp Time | 3 − 20 seconds (adjustable) |
Source: Kutai EG3002 Electronic Engine Governor Controller User Manual
All Kutai Electronics Industry Co., Ltd. EG3002 documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
How do I adjust the idle speed?
Short terminals 2 & 3 and use the IDLE SPEED potentiometer to adjust the idle speed.
From: Kutai EG3002 Electronic Engine Governor Controller User Manual
What is the EG3002 controller used for?
The EG3002 takes a signal from a magnetic pickup and compares it with a preset engine speed to control drive voltage to the actuator to maintain constant engine speed.
From: Kutai EG3002 Electronic Engine Governor Controller User Manual
How do I adjust the idle speed?
Adjust the IDLE Speed potentiometer when terminals 2 & 3 are shorted.
From: Kutai EG3002F Electronic Engine Governor Controller User Manual
What is the recommended speed droop for parallel generator operation?
A speed droop of 2% at maximum load is recommended.
From: Kutai EG3002F Electronic Engine Governor Controller User Manual