Owner's manual for the Wagner Home Décor Paint Sprayer covering safety, setup, spraying, cleanup, maintenance, troubleshooting, parts and warranty.
This is the owner's manual for the Wagner Home Décor Paint Sprayer, a turbine-based HVLP sprayer for household decorative painting. The manual is published in English, French and Spanish, with the English section covering pages 1-8 and including a parts list and warranty information. Wagner Technical Service can be reached at 1-800-328-8251, and setup and spraying videos are referenced at www.homedecorsprayer.com.
The manual explains the sprayer's controls (ON/OFF switch, material flow control, air cap), how to thin sprayable materials such as chalk-type paint, milk paint, latex paint and tempera paint with water, spraying technique for 4-6 inch or 1-2 inch patterns, cleanup with warm soapy water or mineral spirits, and safety precautions including grounding instructions and flash point requirements of at least 100ºF (38ºC).
| Voltage | 120 volt circuit (grounded) |
|---|---|
| Minimum material flash point | 100ºF (38ºC) |
| Container fill lines | 450 ml paint, 500 ml with water (550 ml for darker colors) |
| Spray distance | 3-6 inches (7-15 cm) |
| Spray pattern width | 4-6" wide/tall pattern, 1-2" diameter |
| Extension cord | 3-wire, 14 or 12 gauge recommended |
Chalk, milk, latex and other thicker decorative paints are thinned with water; a 10% dilution is a typical starting point, and transparent stains, clear topcoats and lacquers typically require no thinning.
Use warm, soapy water for chalk-type paint, milk paint and latex materials, and mineral spirits for oil-based materials.
The spray gun should be held 3-6 inches (7-15 cm) away from the spray object, using full passes and light coats.
It is intended for indoor/outdoor household use only with water-based or mineral spirit-type materials having a flash point above 100ºF (38ºC).