Installation and service instructions for the Tuthill 5LE-7 positive displacement rotary gear pump, covering setup, operation, and maintenance.
This manual provides installation and service instructions for the Tuthill 5LE-7 pump, part of the LA and LE Series. These are compact, cast iron positive displacement rotary gear pumps designed for direct drive at standard motor speeds. The document details the pumping principle, proper installation locations, and specific requirements for piping and alignment to ensure safe and efficient operation.
| Series | LA and LE Series |
|---|---|
| Type | cast iron positive displacement rotary gear pumps |
| Capacity Range | .5 gpm (1.9 L/Min) to 14 gpm (53 L/Min) |
| Pressure Range | up to 500 psi (300 psi in the 5LE) |
| Viscosity Range | 35 to 1000 SSU |
| Vacuum Development | 25" mercury vacuum at 0 psi |
| Seal Type | mechanical seal |
The maximum pressure for the 5LE model is 300 psi.
Pumps with ports on the same plane should always be installed with both ports pointing upward to ensure proper priming.
Direct drive through a traditional flexible coupling is recommended.
No, the internal relief valve is designed for overpressure protection only and not for flow control.