This user guide covers the setup, operation, maintenance, and troubleshooting of the TSI SidePak AM510 Personal Aerosol Monitor.
The document provides comprehensive instructions for unpacking and identifying parts of the SidePak AM510 Personal Aerosol Monitor. It details how to supply power using NiMH or AA batteries, install TrakPro data analysis software, and connect the device to a computer.
Subsequent chapters cover operational procedures including survey mode, data logging, statistics, and zero calibration. The guide also includes sections on maintenance for rechargeable battery packs, built-in impactors, and the respirable cyclone, along with troubleshooting advice.
| Sensor type | 90° light scattering, 670 nm laser diode |
|---|---|
| Aerosol concentration range | 0.001 to 20 mg/m3 |
| Particle size range | 0.1 to 10 micrometer (µm) |
| Minimum resolution | 0.001 mg/m3 |
| Zero stability | ±0.001 mg/m3 over 24 hours |
| Operating temperature range | 0 °C to 50 °C (32 °F to 120 °F) |
| Storage temperature range | -20 °C to 60 °C (-4 °F to 140 °F) |
| Flow Rate Range | User-adjustable, 0.7 to 1.8 liters/min (L/min) |
| Time Constant Range | User-adjustable, 1 to 60 seconds |
Factory clean/calibrate is recommended annually.
User zero calibration should be performed before each use.
The software requires a Universal Serial Bus (USB) v1.1 or higher and Microsoft Windows® XP (32-bit) or Windows® 7.