Data sheet for the Tridonic ECCO Smart 2D-TR NFC programmer used to program Tridonic LED drivers.
The ECCO Smart 2D-TR is a mobile barcode and RFID detection device with a performant scan engine and NFC interface. It is used for efficient programming of Tridonic LED drivers by reading a special QR code or together with the 4service NFC mobile app.
The driver must have an NFC interface, and only current can be set. The hardware is produced by FEIG ELECTRONIC, while the Tridonic version differs only in its installed firmware.
| Housing material | Double-walled inside: robust ABS, outside: protective rubber coating |
|---|---|
| Ambient temperature | -20 ... +55 °C |
| Storage temperature | -20 ... +60 °C |
| Type of protection | IP64 |
| Dimensions | 87 x 48 x 26 mm |
| Battery | 1,300 mAh Lithium Polymer, 3.7 V |
| Operation time | up to 16 hours |
| Loading time battery | approx. 3 – 4 hours |
| Loading note | charging via USB mini port, cable included |
| Temperature range loading battery | 0 ... +55 °C |
| Operating frequency | 13.56 MHz |
| Antenna | integrated |
| RF transmitting power | 1.5 W |
| Supported barcodes | 2D DataMatrix, QR Code |
| Protocol | Zhaga Book 25 |
| Indicator LED | (red, green, yellow, blue) |
| Keyboard | 4 keys |
| Interfaces | USB, Bluetooth LE |
| Drop | 1.6 m drop to concrete |
| Environmental conditions | 5 % up to max. 95 %, not condensed |
It is a mobile barcode and RFID detection device with a scan engine and NFC interface for programming Tridonic LED drivers.
By reading a special QR code or using the device together with the 4service NFC mobile app.
The listed article numbers 28003875, 28003876, 28003877, 28003878, 28003879, 28003880, and 28004330 are not supported.
No; it does not have the same functions and cannot be used with Tridonic NFC drivers.