Installation instructions for the Tridonic basicDIM Wireless Passive Module G2, a Bluetooth DALI controller with 4 configurable push-button inputs powered…
The Tridonic basicDIM Wireless Passive Module G2 is a Bluetooth DALI controller featuring 4 freely configurable push-button inputs. It is powered directly by the DALI bus and does not require an additional mains power supply. The antenna is located on the top of the device. The module supports the assignment of up to 4 DALI single or group addresses depending on the device profile, with the remainder of connected drivers controllable via broadcast.
| Supply voltage | DC 9.5–22.5 V |
|---|---|
| Current consumption of DALI | 4 mA (30 mA at start) |
| Max. DALI bus current | 250 mA |
| Typ. power input on stand-by | < 0.09 W |
| Input | 4 push-buttons |
| Max. cable length push button | 5 m at 0.2-1.5 mm² |
| Operating frequency radio receiver | 2.4–2.483 GHz |
| Max. output power radio receiver | + 4 dBM |
| Ambient temperature | -20... +70 °C |
| tc point | 75 °C |
| Dimensions LxWxH | 80.7 x 30 x 15.3 mm |
| Type of protection | IP20 |
No, the module is powered by the DALI bus and does not require an additional mains supply.
Up to 4 DALI single or group addresses can be assigned, depending on the device profile.
It is compatible with Android 4.4 (KitKat) or later, iPhone 4S (iOS 5.0) or later, and iPad 3 (iOS 5.1) or later.