Service manual for the Toyota 2AZ-FE ignition system, covering precautions, parts location, diagrams, inspection, and coil removal/installation.
This document is a section of a service manual for the Toyota 2AZ-FE engine ignition system. It contains precautions, component location, system diagrams, and on-vehicle inspection procedures.
The inspection and repair content includes spark testing, ignition coil power supply and sensor resistance checks, spark plug inspection, and removal and installation of the ignition coil assembly. It lists torque values and recommended spark plug types where stated. This manual is written in Chinese.
| Spark plug installation torque | 19 N*m (194 kgf*cm, 14 ft.*lbf) |
|---|---|
| Ignition coil installation torque | 9.0 N*m (92 kgf*cm, 80 in.*lbf) |
| Standard spark plug insulation resistance | 10 MΩ or higher |
| New spark plug electrode gap | 1.0 to 1.1 mm (0.039 to 0.043 in.) |
| Maximum electrode gap for old spark plug | 1.3 mm (0.051 in.) |
| Recommended spark plugs | DENSO SK20R11, NGK IFR6A11 |
| Ignition coil power supply voltage | 9 to 14 V |
| Camshaft position sensor resistance | Cold: 835 to 1,400 Ω; Hot: 1,060 to 1,645 Ω |
| Crankshaft position sensor resistance | Cold: 985 to 1,600 Ω; Hot: 1,265 to 1,890 Ω |
Remove the engine cover, disconnect the four ignition coil connectors and remove the coils, remove the spark plugs with a 16 mm spark plug wrench, attach each plug to its coil, ground the plug, and crank the engine to check for spark.
The ignition coil bolts are tightened to 9.0 N*m (92 kgf*cm, 80 in.*lbf).
The listed recommended spark plugs are DENSO SK20R11 and NGK IFR6A11.
The standard insulation resistance is 10 MΩ or higher, measured with a megohmmeter.