This manual provides instructions for permanently repairing run-flat, performance, and truck tires using TECH Uni-Seal Ultra repair units and tools.
The TECH RM-4 Repair Manual details the procedures for using the Uni-Seal Ultra repair system to fix punctures in run-flat, performance, standard passenger, light truck, and medium truck tires. It covers the use of specific repair kits (UL3, UL6, UL8, UL10, UL13) and associated tools to ensure repairs meet industry guidelines and manufacturer warranty requirements.
The document outlines critical safety warnings, tire inspection criteria, and step-by-step repair procedures. Key steps include measuring injury size and angle, pre-cleaning the inner liner, buffing the area to a specific texture, and drilling the injury from both inside and outside to remove damaged material before applying the repair unit.
| Maximum injury size for Run Flat tires | 6mm (1/4") |
|---|---|
| Maximum injury size for Passenger tires | 6mm (1/4") |
| Maximum injury size for Light Truck/Truck tires | 3/8" |
| Maximum angle for one-piece repair | 35 degrees |
| Maximum buffer speed | 5,000 rpm |
| Maximum drill speed for carbide cutter | 1,200 rpm |
Yes, run-flat tires can be repaired using the TECH Uni-Seal Ultra or Two-Piece Repair System, provided they are removed from the wheel and inspected.
There is no limit to the number of repairs on a standard passenger tire, as long as no two injuries are in the same radial cord and the repair units do not overlap.
A two-piece repair is required if the injury angle exceeds 35 degrees.