Taiyo Yuden EBSNCN and EKSNCN Series Evaluation Board Manual

Manual for Taiyo Yuden EBSNCN and EKSNCN evaluation boards for the EYSNCN Bluetooth low energy module series.


Taiyo Yuden EBSNCN and EKSNCN Series Evaluation Board Manual - cover page
Brand
TAIYO YUDEN
Category
demo board
Document type
User Manual
Language
English
Pages
9
File format
PDF
File size
1.1 MB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
525A8951AC3AAF3870545F91A169FF57

About this manual

This manual covers the Taiyo Yuden EBSNCN and EKSNCN evaluation boards for the EYSNCN series Bluetooth low energy module. It includes the board introduction, circuit schematic, layout, pin descriptions, and basic usage instructions.

The document also describes board features and setup details such as USB-based UART and power, the SWD connector, LEDs, reset button, current measurement, external power supply, and GPIO UART assignment.

What's inside

  • Introduction
  • Evaluation board circuit schematic
  • Evaluation board layout
  • Pin Descriptions
  • How to use
  • MEMO
  • Size and Coordinate information

Specifications

Mounted moduleEYSNCN Series (9.6mm x 12.9mm x 2.0mm_MAX)
Module processorNordic nRF52811 / ARM Cortex-M4 32-bit processor
Pin header pitch2.54 mm
Distance between CN3 and CN415.24 mm
Default module supply voltage3.3 V

Frequently asked questions

What module are the EBSNCN and EKSNCN boards used with?

They are evaluation boards for Taiyo Yuden's EYSNCN series Bluetooth low energy module.

How is the board powered by default?

It can be connected to a PC with a USB cable, and the module is supplied by default with 3.3V from 3V3OUT of FT232RQ.

How can current consumption be measured?

Cut the short between pins 1 and 2 of CN6, then connect an ammeter between the pins of connector CN6.

What GPIO assignment is used for the UART interface?

P0.05 is RTS, P0.06 is TX, P0.07 is CTS, and P0.08 is RX.

Download PDF (1.1 MB)

More TAIYO YUDEN Manuals


View all TAIYO YUDEN manuals →