Taiyo Yuden EBSHSN/EKS HSN Evaluation Board Manual

Taiyo Yuden EBSHSN/EKS HSN evaluation board manual for the EYSHSN Series Bluetooth low energy module, covering layout, pin descriptions, and setup.


Taiyo Yuden EBSHSN/EKS HSN Evaluation Board Manual - cover page
Brand
TAIYO YUDEN
Category
Board
Document type
User Manual
Language
English
Pages
8
File format
PDF
File size
1.2 MB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
570A4D7245A50A0F693BCC99E4B5447D

About this manual

The EBSHSN and EKS HSN evaluation boards are for Taiyo Yuden’s EYSHSN Series Bluetooth low energy module. The mounted EYSHSN module measures 8.55 mm x 3.25 mm x 0.85 mm max; the EKS HSN kit also includes a J-Link Lite.

The manual shows the evaluation board circuit schematic and layout, lists pin descriptions for CN3, CN4, and CN8, and explains setup over USB. It also covers current measurement, external power, USB-to-UART driver installation, board size and coordinates, and a 32 kHz clock note.

What's inside

  • Introduction
  • EBSHSN Series Evaluation Board
  • EKSHSN Series Evaluation Kit
  • Evaluation board circuit schematic
  • Evaluation board layout
  • Silkscreen Printing Pin Descriptions
  • How to use
  • MEMO
  • Size and Coordinate information
  • Important notes: 32kHz Clock

Specifications

Mounted moduleEYSHSN Series
Module dimensions8.55 mm x 3.25 mm x 0.85 mm max
ProcessorNordic nRF5 2832 / ARM Cortex-M4F 32-bit processor
Pin header pitch2.54 mm
CN3-CN4 distance15.24 mm
Default module power3.3 V from 3V3OUT of FT232RQ
CN2 connectorminiUSB - UART +5V DC power supply

Frequently asked questions

What module is used on the evaluation board?

The board is for the EYSHSN Series Bluetooth low energy module, and the mounted module is EYSHSN.

How is the board connected to a PC?

It connects to a PC with a USB cable, and no board setting change is needed.

How do I measure current consumption?

Cut the shorting 1-pin and 2-pin of CN6, then connect an ampere-meter between the CN6 pins.

Does the module have a 32.768 kHz crystal?

The module does not have a 32.768kHz crystal installed; the SDK config can be modified to enable the internal 32.768kHz RC oscillator.

Download PDF (1.2 MB)

More TAIYO YUDEN Manuals


View all TAIYO YUDEN manuals →