Operator's manual for the Simpson WB4200SP belt-drive cold water pressure washer, covering safety, operation, maintenance, detergent use, and warranty.
This manual is for the Simpson WB4200SP belt-drive cold water pressure washer. It covers safety do's and don'ts, machine preparation, hose connections, starting and stopping, pressure washing, detergent application, nozzles, maintenance, pump diagnosis, and warranty.
The manual emphasizes safe operation, including face protection, keeping hands and feet clear of the nozzle, ventilated operation, and proper water supply. It also describes machine preparation, hose connections, and stopping steps such as releasing system pressure before disconnecting hoses.
Wear proper face protection, keep hands and feet clear of the cleaning nozzle, operate only in well ventilated areas, and use only recommended parts and accessories.
The incoming water supply must deliver gallons per minute greater than machine capacity, and the machine should connect only to clean city water supply or a deep domestic well.
Locate the machine on a level plane, turn on the water supply, pull the gun valve trigger to let air escape, and release the trigger when water flows in a full steady stream.
Flush chemicals if used, let the machine run for one minute without load, shut it off, pull the recoil starter until compression resistance is felt, close the fuel valve, turn off the water, remove the nozzle, and release pressure before locking the trigger.