Instruction manual for the ROHDE TS 20 pugmill covering setup, operation, cleaning, maintenance, safety devices and technical data.
The ROHDE TS 20 is a pugmill for processing and homogenizing clays and porcelain masses, mixing different masses and mixing in fireclays. The manual explains unpacking, installation, switching on, feeding clay, cleaning and maintenance.
It also describes the three protection devices—injury protection, motor overload protection and a safety switch—and lists technical data such as motor performance, electrical connection, dimensions, throughput and noise level.
| Motor performance | 1,5 kW at 1400 U/min |
|---|---|
| Electric connection | 230 Volt / 16 A |
| Strang diameter | 80 mm |
| Maximum throughput | 600 kg/h |
| Height | 1100 mm |
| Width | 550 mm |
| Depth | 1100 mm incl. shelf |
| Noise level | 76 dB (A) |
| Worm gear motor speed | 14 rpm at the input shaft |
| Transmission oil | 0.5 liters of commercially available synthetic transmission oil, SAE 85 W 90 |
| Transmission oil change interval | Every 4,000 operating hours or after 4 years at the latest |
It processes and homogenizes clays and porcelain masses, and can mix different masses together and mix in fireclays. It is not suitable for processing clay flour with water.
Check that the rotating direction of the output shaft matches the red arrow on the mixing rod. If it does not, an electrician must switch two phases in the plug.
The motor safety switch responds. It switches back on automatically after a cooling-down period of about 3 minutes once the cause has been resolved.
Change it every 4,000 operating hours, or after 4 years at the latest.