PCB Piezotronics Model 105C12 Subminiature ICP Pressure Sensor Installation and Operating Manual

Installation and operating manual for the PCB Piezotronics Model 105C12 Subminiature ICP pressure sensor, covering setup, calibration, and safety.

Brand: PCB Piezotronics
Category: sensor
Document type: User Manual
Language: English
Pages: 11
File format: PDF
File size: 808 KB
Published: 29 October, 2026
Updated: 29 October, 2026
MD5 checksum: 161CB6A0A034D4D42E87054D0EC38959
PDF: PCB Piezotronics Model 105C12 Subminiature ICP Pressure Sensor Installation and Operating Manual PDF

About this manual

This document is the Installation and Operating Manual for the PCB Piezotronics Model 105C12 Subminiature ICP pressure sensor. It is designed for measuring dynamic pressures in limited spaces and includes instructions for installation, operation, calibration, and safety considerations. The manual also provides information on warranty, repair procedures, and hazardous material compliance.

What's inside

Introduction
Description
Installation
Model 105A
Models 105C02, C12 & C22
Models 105C03, C13, 23, C33, C43
Flash Temperature Protection
Recessed Installation
Calibration
Safety Considerations

Specifications

Full-scale range	1000 psi
Sensitivity	5 mV/psi
Diaphragm diameter	0.099 inch
Mounting thread	10-32 mtg thd
Output impedance	less than 100 ohms
Bias voltage	+11 volt (nominal)

Frequently asked questions

How often should the sensor be calibrated?

We recommend calibrating on an annual basis, after exposure to any extreme environmental influence, or prior to any critical test.

What is the recommended cable for Model 105C sensors?

Use coaxial 002G10 cable, 5-44 to 10-32 microdot.

Download PDF (808 KB)