Operation manual for the OMRON CS1D-ETN21D 100Base-TX Ethernet Unit for CS1D PLCs, covering installation, setup, FINS communications, and troubleshooting.
The OMRON CS1D-ETN21D is a 100Base-TX Ethernet Unit for CS1D PLCs in the SYSMAC CS Series. The operation manual, Cat. No. W430-E1-01 and produced January 2004, describes installation and operation of the unit, including switch settings, mounting to a PLC, network installation, connecting to the network, creating I/O tables, and enabling duplex communications.
It also covers CX-Programmer Unit Setup, CIO and DM Area memory allocations, IP address determination, FINS communications using the FINS/UDP and FINS/TCP methods, and FINS commands addressed to Ethernet Units. Troubleshooting chapters address indicators, error status, error logs, and response codes, and the appendices cover Ethernet network parameters, buffer configuration, TCP status transitions, ASCII characters, maintenance, and inspections.
| Model | CS1D-ETN21D |
|---|---|
| Series | SYSMAC CS Series |
| Network type | 100Base-TX |
| Communications service | FINS communications |
The CS1D-ETN21D is a 100Base-TX Ethernet Unit for CS1D PLCs, covered by OMRON operation manual W430-E1-01.
It describes installation and operation of the unit and includes sections on features, system configuration, setup, memory allocations, IP addresses, FINS communications, FINS commands, and troubleshooting.
CX-Programmer is used for Ethernet Unit setup, as covered in Section 3 of the manual.
The manual number is W430-E1-01, shown on the cover as Cat. No. W430-E1-01.