Mettler-Toledo ACT100xx Weighing Transmitter Zone 2 Installation Manual

Mettler-Toledo ACT100xx weighing transmitter Zone 2 installation manual covering installation rules, special conditions, temperature class and wiring diagrams.


Mettler-Toledo ACT100xx Weighing Transmitter Zone 2 Installation Manual - cover page
Brand
METTLER-TOLEDO
Category
Industrial Supply
Document type
Installation Guide
Language
Chinese
Pages
19
File format
PDF
File size
1.6 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
5A8833F03BAC89F8EEAE939F0E2C1DBE

About this manual

This is the Chinese-language Zone 2 installation manual for the Mettler-Toledo ACT100xx weighing transmitter (document 30529642 | 00 | 06/2020). It opens with Mettler-Toledo service information such as product registration, service agreements, initial calibration documentation, periodic calibration and GWP verification, followed by copyright, FCC and disposal notices, and a warnings section.

The main chapters cover the introduction and product marking, installation regulations and requirements, non-sparking certification, temperature class, special requirements for the housing and special conditions of use, and the certification documents including the installation wiring diagram. The manual states that installation in Zone 2 must refer to drawing 30562232 and that the device must not be used in Zones 0, 1, 20 or 21. This manual is written in Chinese.

What's inside

  • 简介
  • 概述
  • 产品标记
  • 安装规程
  • 安装要求
  • 无火花认证
  • 温度组别
  • 外壳
  • 特殊使用条件
  • 认证文档

Specifications

Temperature class (gas)T4 (135 °C)
Permitted hazardous areaZone 2 only; not for Zones 0, 1, 20, 21
Installation drawing for Zone 230562232
FCC complianceFCC Rules Part 15, Class A digital device limits
Quality certifications of the producing factoryISO9001, ISO14001, GB/T28001

Frequently asked questions

Which hazardous zones can the ACT100xx be used in?

The ACT100xx may be installed in Zone 2 only; it must not be used in flammable or explosive gas atmospheres of Zones 0, 1, 20 or 21.

What temperature class does the ACT100xx have for gases?

For gases the transmitter has temperature class T4 (135 °C), so it must not be used where the ignition temperature of the hazardous substance is below this class.

Which drawing must be referred to when installing the ACT100xx in Zone 2?

Installation drawing 30562232 must be referred to; improper installation can cause personal injury and property damage.

What must be done before cleaning or maintenance?

The power supply to the device must always be disconnected before cleaning or performing maintenance.

Download PDF (1.6 MB)

More METTLER-TOLEDO Manuals


View all METTLER-TOLEDO manuals →