The Linear Technology DC2302A demonstration kit manual provides operation, specifications, parts list, and wiring diagrams for the LTC4123EDC low‑power…
The DC2302A demonstration kit consists of the DC2300A receiver board and the DC2301A transmitter board, both built around the LTC4123EDC low‑power wireless charger IC. The kit is intended for engineering development and evaluation of a low‑power NiMH battery charger that operates via resonant wireless power transfer.
The manual details how to power the kit from a USB source, measure voltage ripple, install the NiMH battery, and understand the schematic and component specifications. Safety notices, parts lists, and recommended coil configurations are also included to help users evaluate the design safely and effectively.
| VIN (DC2301A) Voltage Input | 4.5 V – 5.5 V |
|---|---|
| Maximum USB Current Draw | < 100 mA |
| Air Gap Range | 0.8 mm – 4.0 mm |
Connect the oscilloscope probe tip directly across the signal and ground terminals, avoiding a long ground lead, as described in the demo board procedure.
The kit must draw less than 100 mA from a USB port, complying with USB peripheral requirements.