User manual for the Intellijel Buff Mult 1U, a dual 1 x 4 buffered signal multiplier for 1U Eurorack rows, covering installation, operation and specs.
This manual covers the Intellijel Buff Mult 1U, a dual 1 x 4 buffered signal multiplier designed for use within an Intellijel-standard 1U row, such as the Intellijel 4U and 7U Eurorack cases. It opens with the compliance statements for the device and then explains what to check before installing a module: available power headers, total current draw for +12V, -12V and +5V, and free space in the case.
The installation section describes connecting the 10-pin power cable with the red stripe aligned to the -12V pins and the 16-pin end to the case bus board. The operation section explains how buffered mults differ from passive mults and how the two sections of the module duplicate an input to four outputs each, with the top input normalled to the bottom input so that a single signal can be sent to all eight outputs. Technical specifications are listed at the end.
| Width | 14 hp |
|---|---|
| Maximum Depth | 29 mm |
| Current Draw (+12V) | 4 mA @ +12V |
| Current Draw (-12V) | 4 mA @ -12V |
It is a dual 1 x 4 buffered signal multiplier that takes an input signal and routes it to multiple outputs simultaneously.
The top input jack is normalled to the bottom input jack, so the top input is duplicated across all 8 outputs, making the module act as a single 1 x 8 buffered multiplier.
It is designed for an Intellijel-standard 1U row, such as the Intellijel 4U and 7U Eurorack cases.
Buffered mults make electrical copies of an input voltage and isolate their outputs from the input, so shorts at the input do not pass through and voltage-critical signals such as 1V/Oct are accurately duplicated.