EXAR XRD9827TREF Evaluation Kit User Manual - Toshiba CIS 36-Bit Color Single Line Scanner

User manual for the EXAR XRD9827TREF evaluation kit, which interfaces a Toshiba 600 DPI CIS with the XRD9827 sensor signal processor for single line scanning.


EXAR XRD9827TREF Evaluation Kit User Manual - Toshiba CIS 36-Bit Color Single Line Scanner - cover page
Brand
EXAR
Category
demo board
Document type
User Manual
Language
English
Pages
18
File format
PDF
File size
183 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
57B504F5AC8B577220E3A02A66206F3A

About this manual

This manual describes the EXAR XRD9827TREF, a demo system that pairs a Toshiba CIPS218MC600 600 DPI color Contact Image Sensor (CIS) with the XRD9827, a 12-bit linear CIS/CCD sensor signal processor. The kit demonstrates how to output a single line scan and display the offset and gain corrected amplitude of each of the three colors. The board carries the XRD9827, an Altera EPM7128SLC84 FPGA that generates timing signals, two FIFO SRAMs, and peripheral circuits for the CIS.

The manual lists the kit contents (scanner board, SenseIt 1.0 software diskettes, XRD9827 data sheet, scan targets), the PC system requirements, and step-by-step operating instructions: connecting the parallel port cable, installing the SenseIt software, configuring the printer port, setting the dip switches, and running black target scans to calibrate offset and gain. Schematics of the reference board are included at the end.

What's inside

  • Evaluation Kit Part List
  • Features
  • System Requirements
  • Introduction
  • Operational Procedure
  • How to Run the XRD9827TREF Demonstration
  • Loading EXAR Software
  • Parallel Port Configurations
  • Offset Adjustment With a Black Target
  • Block Diagram

Specifications

Image sensorToshiba CIPS218MC600 600 DPI color Contact Image Sensor (CIS)
Signal processorXRD9827 12-bit linear CIS/CCD sensor signal processor
ADC resolution12-bit
Programmable gain6-bit PGA, gain adjustment 1 to 10
Offset calibration8-bit, input-referred range of 800 mV
Pixels per line5148
PC interfaceParallel port (DB25)
PCBFour layers
Minimum systemIntel 486 compatible PC, Windows 95, 8 MB memory
FPGAAltera EPM7128SLC84

Frequently asked questions

What pixel number should I enter in the SenseIt software?

Enter 5148, which is the number of pixels of one line.

What parallel port address does the kit use?

The Input/Output Range should be 0378 - 037Fh; the default setting in the SenseIt software is 378H.

What are the system requirements for the XRD9827TREF?

An Intel 486 compatible computer with Windows 95, 8 MBytes of system memory, a 25-pin D-shape parallel port receptacle, and a 3 1/2" floppy disk drive.

Download PDF (183 KB)

More EXAR Manuals


View all EXAR manuals →