EPEVER LS-EU Series solar charge controller user manual covering safety, installation and wiring, LED indicators, settings, protection and specifications.
The EPEVER LS-EU Series solar charge controller is a PWM controller with a USB output. The series covers the LS0512EU and LS1012EU (12VDC nominal system voltage, 30V maximum PV input voltage, 5A and 10A nominal charge/discharge current) and the LS1024EU and LS2024EU (12/24VDC, 50V maximum PV input voltage, 10A and 20A). All models provide a USB output of 5VDC/1.2A. The controller supports Series PWM charging with three charging options (Sealed, Gel and Flooded), temperature compensation, battery status LEDs and electronic protection against overload, short circuit, over discharge, over voltage, low voltage and reverse polarity.
This user manual presents important safety information and general information, then installation instructions for mounting and wiring, followed by operation of the LED indicators and setting operation. Protection and troubleshooting are covered in a separate section, and the manual closes with electrical, environmental and mechanical technical specifications. This edition is version V1.6 and is published by BEIJING EPSOLAR TECHNOLOGY CO., LTD.
| Nominal System Voltage | LS0512EU/LS1012EU: 12VDC; LS1024EU/LS2024EU: 12/24VDC |
|---|---|
| Maximum PV Input Voltage | LS0512EU/LS1012EU: 30V; LS1024EU/LS2024EU: 50V |
| Nominal Charge/Discharge Current | LS0512EU: 5A; LS1012EU/LS1024EU: 10A; LS2024EU: 20A |
| USB Output | 5VDC/1.2A (all models) |
| Charge Circuit Voltage Drop | ≤0.26V |
| Discharge Circuit Voltage Drop | ≤0.15V |
| Self-consumption | ≤6mA |
| Temperature Compensation Coefficient | -5mV/℃/2V (ref) |
| Working Temperature | -35℃ to +55℃ |
| Enclosure | IP20 |
| Dimensions and Weight | LS0512EU: 109.7x65.5x20.8mm, 95g; LS1012EU: 120.3x67x21.8mm, 103g; LS1024EU: 120.3x67x21.8mm, 102g; LS2024EU: 148x85.6x34.8mm, 179.6g |
| Terminal Size | 2.5mm² (LS0512EU), 4mm² (LS1012EU/LS1024EU), 6mm² (LS2024EU) |
The USB output provides 5VDC/1.2A and can charge electronic equipment.
It supports three charging options: Sealed, Gel and Flooded, and should be used with these battery types only.
Connect the components in the sequence shown in the manual and always power the battery first.
Select the system cables according to 3.5A/mm2 current density.