Manual and performance data sheet for the Elkay WaterSentry Plus EWF3000 water filter, with use conditions, contaminant reduction data, installation and…
This document is the manual and performance data sheet for the Elkay WaterSentry Plus EWF3000 water treatment system. It states the recommended use conditions, lists certified contaminant reduction results tested according to NSF/ANSI 42 and 53, and includes installation and filter replacement instructions plus a limited warranty.
The system is certified by IAPMO R&T for the reduction of particulate Class I, chlorine (taste and odor), lead, and cysts. It is for use on the cold water line only and must not be allowed to freeze. The document also notes that installation and usage must comply with applicable local and state regulations.
| Replacement element | 51300C |
|---|---|
| Working pressure | 20 – 105 psi (241 – 724 kPa) |
| Operating temperature | 40 – 100° F (5 – 38° C) |
| Flow rate | 1.5 GPM (5.7 L/min) |
| Capacity | 3,000 gal (11,356 L), 1 year maximum |
| Particulate, Class I reduction | ≥ 85% reduction (0.5 to < 1 µm) |
| Chlorine, taste and odor reduction | ≥ 50% reduction |
| Lead reduction | 0.15 mg/L influent reduced to 0.005 mg/L |
| Cyst reduction | ≥ 99.95% reduction |
| Certification | IAPMO R&T certified, tested to NSF/ANSI 42 and 53 |
The system has a capacity of 3,000 gallons (11,356 L) with a maximum service life of 1 year.
No. The unit is for use on the cold water line only, and the installed filter must not be allowed to freeze.
Turn on the water supply and run water for 10 minutes to purge air and fine carbon particles from the filter, then reset the filter monitor if necessary.