ELEKTRA SnowTec and SnowTec Tuff Heating Mats Installation Manual

Installation manual for ELEKTRA SnowTec and SnowTec Tuff heating mats, covering applications, cable structure, technical data, controls, and installation steps.


ELEKTRA SnowTec and SnowTec Tuff Heating Mats Installation Manual - cover page
Brand
ELEKTRA
Category
Heater
Document type
Installation Guide
Language
English
Pages
84
File format
PDF
File size
4.3 MB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
2719E93F83FA7F530E3E6CD7B20275AC

About this manual

ELEKTRA SnowTec and SnowTec Tuff heating mats are ready-made units intended to prevent snow and ice deposition on driveways, roads, parking spaces, terraces, viaducts, bridges, and loading ramps. Depending on the surface, they are laid in a layer of sand or dry concrete, directly in concrete, or, for SnowTec Tuff, directly in asphalt.

The manual describes the cable structure, dimensions, heat output, supply voltages, minimum installation temperatures, and controls including ELEKTRA ETR2 and ETO2 DIN-bus controllers, plus ETOG2, ETR2G, and SMCG snow and ice protection controls. It also gives installation stages and notes on joints, cold tails, and surface preparation.

What's inside

  • Applications
  • Cable structure
  • Characteristics
  • General information
  • Controls
  • Snow & ice protection controls
  • Installation Stage 1: Heating mat’s installation
  • Flagstones, paving cobbles and asphalt surfaces

Specifications

Width (SnowTec)40 and 60 cm
Width (SnowTec Tuff)60 cm
Length (SnowTec)2 to 25 m
Length (SnowTec Tuff)1.5 to 27 m
ThicknessApprox. 7.5 mm
Cold tail length4 m
Surface heat output (SnowTec)300 W/m2
Surface heat output (SnowTec Tuff)400 W/m²
Power supply (230 V models)230 V
Power supply (400 V models)400 V
Minimum installation temperature-5°C (SnowTec); -25°C (SnowTec Tuff)

Frequently asked questions

What are ELEKTRA SnowTec heating mats used for?

They are intended to prevent snow and ice deposition on driveways, roads, parking spaces, terraces, viaducts, bridges, and loading ramps.

Can SnowTec Tuff heating mats be installed directly in asphalt?

Yes. SnowTec Tuff mats can be installed directly in asphalt, and they can also be installed directly in concrete.

What is the rated voltage of the heating mats?

SnowTec and SnowTec Tuff mats are rated for 230 V, 50 Hz; the 400V versions are rated for 400 V, 50 Hz.

Can the heating cable be cut to fit the surface?

No. The heating cable must never be cut; only the cable connecting tape can be cut to shape the mat.

Download PDF (4.3 MB)

More ELEKTRA Manuals


View all ELEKTRA manuals →