Elektra ELR-10 Electronic Temperature Controller Installation Manual

Installation and use guide for the Elektra ELR-10 electronic temperature controller for heating systems.


Elektra ELR-10 Electronic Temperature Controller Installation Manual - cover page
Brand
ELEKTRA
Category
Other Electronics
Document type
Installation Guide
Language
English
Pages
56
File format
PDF
File size
459 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
98D80EBA0275D8654573CA28F83A94C7

About this manual

The Elektra ELR-10 electronic temperature controller manages power to heating elements to reach the required temperature and reduce electricity consumption. It supports air sensor, floor sensor, or air and floor sensor temperature measurement, with controller preparation depending on the selected method.

The manual covers floor sensor installation, controller installation and wiring, switching on and adjustments, technical specifications, and warranty conditions. The controller is rated for 230 VAC/50 Hz supply and heating devices up to 3600 W, with temperature adjustment from +5°C to +35°C.

What's inside

  • Introduction
  • Classification
  • Installing the floor sensor
  • Installing the controller with built-in air sensor
  • Installing the controller with built-in air or floor sensor and additional sensor limiting floor temperature to +40°C
  • Technical specifications
  • Installing the controller
  • Switching the controller on and its adjustments
  • Warranty conditions

Specifications

Power supply voltage230 VAC/50 Hz
Power loadmax 3600 W (res.) at cos φ=1
Temperature adjustment range+5°C to +35°C
Sensitivity≤0.5°C (floor 1°C)
Safety classIP 20
Dimensions (h/w/l)80 x 82 x 36 mm
Installationsurface mounting
Control lightLED
Switch1 pole

Frequently asked questions

What temperature measurement methods does the ELR-10 support?

It supports air sensor, floor sensor, and air and floor sensor measurement methods.

What is the maximum power load for the heating device?

The heating device load is up to 3600 W (resistive) at cos φ=1.

How far can the floor sensor wire be extended?

The sensor wire can be extended up to 50 m in length.

Download PDF (459 KB)

More ELEKTRA Manuals


View all ELEKTRA manuals →