Quick start and safety manual for the Druck DPI 610E portable pressure calibrator, covering models, safety, IS use and setup.
The DPI 610E is a handheld pressure calibrator with a built-in manual pressure pump and electrical measurement and simulation. It is available in intrinsically safe (IS) and non-intrinsically safe (Non-IS) variants, with hydraulic and pneumatic models covering specified pressure ranges.
This Quick Start & Safety Manual presents safety warnings and cautions, model and pressure-range information, and requirements for the IS variants. It also covers product markings, installation, batteries, the accessory socket, specific conditions of use and declaration requirements.
| DPI 610E-HC/SHC pressure range | 70 - 1000 bar (1000 - 15000 psi) |
|---|---|
| DPI 610E-PC/SPC pressure range | 0.35 - 35 bar (5 - 500 psi) |
| Maximum working pressure | 1.2 × MWP |
| Power supply input | 90 – 264 Vac, 50 to 60Hz, 300-600mA |
| Battery type | Lithium-ion (Li-ion) battery pack |
| Specified charger part | IO610E-PSU |
| Maximum terminal voltage | 30V CAT I |
| Mains supply ambient temperature | 0 to 40°C (32 to 104°F) |
It is intended for calibrating pressure sensors and transmitters by service or maintenance engineers.
The DPI 610E-HC covers 70 to 1000 bar (1000 to 15000 psi).
Use only the Druck specified power supply/charger, Part IO610E-PSU.
Overpressure must be limited to 1.2 × MWP.