Danfoss design guide for the VLT HVAC Drive FC 100 series (software 2.5x), covering selection, installation, application examples and RS-485 setup.
This is the Danfoss design guide (document MG.11.B5.41) for the VLT HVAC Drive FC 100 series. It applies to all VLT HVAC drives with software version 2.5x, which can be read out in parameter 15-43. The guide starts with reading instructions, certifications, symbols, abbreviations and definitions for the drive. This manual is written in Chinese.
| Software version covered | 2.5x |
|---|---|
| Analog inputs | 3 inputs: 0-10 VDC, 0-20 mA, 4-20 mA |
| Analog outputs | 3 outputs, 0-10 VDC |
| External 24 V DC input voltage range | 24 V DC ±15% (max 37 V for up to 10 s) |
| External 24 V DC max input current | 2.2 A |
| External 24 V DC average input current | 0.9 A |
| Max cable length, external 24 V DC supply | 75 m |
| Power-up delay, external 24 V DC supply | < 0.6 s |
It covers all VLT HVAC drives with software version 2.5x.
The software version can be read out in parameter 15-43.
The design guide is numbered MG.11.B5.41.
The maximum cable length is 75 meters.