CMP 25100, 25120 and 25140 inground pool skimmer operation instructions covering water level, flow adjustment, vacuuming and float valve use.
These CMP instructions cover operation for all skimmers and list CMP 25100, 25120 and 25140 skimmers. Water is pulled through the skimmer by pump suction, floating debris is collected in the skimmer basket, and the floating weir is described as improving water flow and efficiency.
The document explains keeping the pool water level at least 2 inches above the bottom of the skimmer mouth, adjusting flow with the diverter plate, and using the float valve. It also covers vacuuming, the equalizer check valve, replacement parts, and the water bond and zinc anode.
| Skimmer models | CMP 25100, 25120, 25140 |
|---|---|
| Minimum pool water level | At least 2 inches above the bottom of the skimmer mouth |
| Water bond copper wire surface area | Over 9 in²; meets NEC section 680.2 C |
| Zinc anode replacement part number | 25810-140-000 |
| Residential use | Do not use the equalizer line; plug it using NSF listed PVC cement |
The water level should be kept at least 2 inches above the bottom of the skimmer mouth.
It automatically closes over the flow ports and diverts all water flow to the pump from the main drain line, preventing possible air lock.
Turn off the pump for 10-15 seconds; the float valve will rise to the top of the skimmer cavity.
Remove the cover, basket and float valve assembly, screw the hose adapter into the pump port, fill the hose with water, and insert it over the adapter; alternatively, insert the skimmer vacuum on top of the basket.