Installation manual for a C-306 shower enclosure and bath screen, covering cautions, tools, packing list, silicone sealing and cleaning.
This installation manual covers a shower enclosure with a bath screen. It opens with cautions, then lists the tools required for the job - pencil, drill bit, silicone and gun, flat head and cross head screwdriver, tape measure, spirit level, drill and rubber hammer - and gives a packing list with item codes such as E1-457, E1-458, E1-453, E1-455, E1-432, B-673, C-306, C1-007, ST4+30 and 1-306 with their quantities. A product schematic diagram follows the packing list.
The manual explains that silicone should be applied on the outside edge of the bath screen, between the wall profiles and the wall and between the frame and the bath, to improve waterproofing, and that it must dry for 24 hours before use. A closing section gives cleaning and maintenance advice: remove sundries regularly so the drain does not jam, clean with a mop and mild detergent, avoid irritant cleaners such as alcohol or gasoline, use toothpaste on a cloth for stains and rinse afterwards, and add a small quantity of lubricant to the roller wheel, slipping hook and track if the glass door is noisy.
| Silicone drying time before use | 24 hours |
|---|
The silicone needs 24 hours to dry after installation before the enclosure is put into use.
A pencil, drill bit, silicone and gun, flat head and cross head screwdriver, tape measure, spirit level, drill and rubber hammer.
Clean it usually with a mop and mild detergent, and do not use irritant detergents such as alcohol, gasoline or other chemical cleaner.
Add a small quantity of lubricant onto the roller wheel, slipping hook and the track.